Basic Electrical Wiring Light Switch. Once done, free the terminal wires, using pliers if. Web if bulbs connected to a dimmer are flickering, this is likely the reason why.
If you run into short wires, there’s an easy fix. Web wiring a light switch is very simple. Web i have an outdoor shed light switch that controls a light.
Next connect the blue neutral from the supply cable. The only wires i found attached to the old switch was. Web leave the wires long enough to protrude at least 3 in.
Loose or poor wiring behind the switch could also cause flickering. Disconnect the terminal and ground wires. The white (neutral) wire from the power source and the white (neutral) wire that goes to the light fixture get connected to.
Loosen the screws holding the terminal wires in place. Once done, free the terminal wires, using pliers if. Web once isolated run a supply cable down from the ceiling rose and connect the brown live up to the l1 terminal of the first switch.
See the full instructions here: Again…the electrical circuit’s white wires bypass the switch unless…a white wire. Web if bulbs connected to a dimmer are flickering, this is likely the reason why.
